Back to Global FoodMate |Add To Favorites | Browse
regular members

Carol R. Miller

smart board interactive whiteboard

Saturday,Nov 23, 2024
Product category
  • No categories temporary
Search
 
Certifications
  • not upload temporary
Friendly link
  • no link temporary
Current Position:Home » Our News » 86 smart board
Our News
86 smart board
Posted:Jun 08, 2022        Views:345        Back to List
 Everyone in the use of touch screen control in the 86 smart board all-in-one or industrial integration, frequently touch screen response is not sensitive or can't touch. This is what causes, industrial control fault is mainly due to touch touch screen machine Settings or hardware problems caused by the touch of the following is a general industrial control touch screen machine sharing and solve the problem
1,By finger touch position did not overlap with the mouse arrow. This kind of phenomenon is mainly after installing the driver, in the correct position, there is no vertical touch bull 's-eye center position.
Solution: to correct position. After installing smart board for conference room the driver for the correction for the first time, pay attention to the details of the observation system error. Didn't find control card, touch screen is not connected, etc., according to the prompt to check the corresponding parts.
2, Industrial control area of the touch screen machine touch accurately, area of the touch have deviation.
This kind of phenomenon is a touchscreen smart boards for conference rooms acoustic reflection stripes above accumulated a large amount of dust or scale, caused by the effect of acoustic signal transmission. The solution: clean the touch screen, touch screen will pay special attention to the 4 acoustic reflection stripe is clean, clean the touch screen control card should be power off.
3 Touch screen, touch screen control in the machine operation, but the computer can not work normally when the host is connected, the computer can't operate.
Solution: according to the analysis of the smartboard for business reasons are: it could be control in industrial control touch screen all-in-one touch screen driver version is too low, you need to install the latest drivers. May also be in the host start loading control in industrial control touch screen before all-in-one touch screen driver, industrial touch screen control in the all-in-one touch screen control card receives the operation, just after power again, restart the computer.
4, Touch not: a surface acoustic wave touch screen, industrial smartboards for business touch screen machine control in the fingers touch display screen part is not completed properly the corresponding operation.
Solution: according to the analysis of the reasons are: may be a reflection of acoustic screen stripe have been damaged, if you encounter this kind of situation will not be able to fully repair; Touch screen may also be a touch screen control in the machine in use after a period of time, the reflection stripe around the screen is covered by dust above, use a dry soft cloth to wipe, then power, restart the computer and recalibrate.